Lion News
8/9/2011
Question of the Week: Hazardous Air Pollutants: Part 61 vs. Part 63
Q. What is the difference between the “original” National Emissions Standards for Hazardous Air Pollutants (NESHAPs) of 40 CFR 61 and the “new” NESHAPs of 40 CFR 63?
A. Congress, through the Clean Air Act (CAA) of 1970, required the EPA to identify Hazardous Air Pollutants (HAP) and promulgate standards for each HAP. Between 1971 and 1990, the EPA...
8/2/2011
Question of the Week: Hazard Communication for CESQGs
Q. We are a conditionally exempt small quantity generator (CESQG). We hold waste on site in a central storage area for up to six months before we ship everything off site, but we don’t follow the actual 180–day rules while we’re storing the waste. We mark the words “Hazardous Waste” on our containers but nothing else. Since some of the waste is flammable, do we need to label the containers with either DOT labels or OSHA hazard communication labels while we’re storing them...7/29/2011
President Announces Next Steps in Vehicle Fuel Economy
On July 29, 2011, President Obama announced the next stage in increasing fuel economy for vehicles sold in the U.S. According to the rule, the corporate average fuel economy rating will be bumped up to 54.5 miles per gallon by 2025. That’s a significant bump from the current 35.5 mpg that the manufacturers have to...7/26/2011
PHMSA Responds to Petitions, Revises Special Permit Application Procedures
On January 5, 2011 (76 FR 454), the U.S. Department of Transportation (DOT) Pipeline and Hazardous Materials Safety Administration (PHMSA) published amendments to the application procedures for hazardous material special permits. These amendments required applicants for special permits to provide more information about their operations so that PHMSA could better evaluate the safety impact of...7/26/2011
New Issues for Hazardous Waste Recycling
The EPA is proposing further amendments to the hazardous waste regulations in order to encourage the recycling of hazardous secondary materials while protecting low-income and minority communities from pollution. This proposal would limit the opportunities for waste generators to exclude hazardous secondary materials intended for recycling from the hazardous waste regulations. This proposal also introduces...7/26/2011
EPA Proposes Revised Definition of Solid Waste
Today, the Federal Register published the EPA’s latest attempt to redefine solid waste in a way that safeguards public health and the environment while also promoting the recycling of hazardous materials.
Today’s rule proposal was first announced over a week ago when Administrator Jackson signed the proposal just in time to comply with a consent decree between...
7/26/2011
New Rules from Fedex Ground for Hazmat Shipments
If you’ve ever tried to ship hazmat overnight, you probably know that Fedex does not accept any shipments of dangerous goods unless you first let them give you a once-over and approve your shipping procedures.
You may not know that “effective August 1, 2011, FedEx Ground will require all hazardous materials paperwork to be completed and...
7/20/2011
Miscellaneous Amendments to Hazmat Regulations
On July 20, 2011, at 76 FR 43510 the Pipeline and Hazardous Materials Safety Administration (PHMSA) amended the Hazardous Material Regulations (HMR) to make miscellaneous amendments to update and clarify certain regulatory requirements.
These amendments were based on petitions from the regulated community and PHMSA’s own initiative. The amendments are intended to update, clarify, or provide...
7/19/2011
Question of the Week: DOT Rules for Reusing Drums for Shipping Hazardous Waste
Q. As a small manufacturer, we buy lots of chemicals each month to use as solvents, purifiers, or catalysts. When we’re done, we ship the used chemicals back to the supplier for recycling and, in many cases, eventual reuse.
Most of the time, when we return-ship this hazardous waste, we refill the waste material into the...
7/12/2011
Question of the Week: PCB Waste Management
Q. We are doing some building maintenance and have removed or replaced a number of our fluorescent lighting fixtures. As a result, we have an assortment of lighting ballasts. I know that polychlorinated biphenyls (PCBs) are regulated under TSCA and not RCRA. Can I presume that our lighting ballasts contain less than 50 ppm PCBs? If not....
Download Our Latest Whitepaper
A guide to developing standard operating procedures, or SOPs, that help you select, manage, and audit your hazmat agents and contractors.
By submitting your phone number, you agree to receive recurring marketing and training text messages. Consent to receive text messages is not required for any purchases. Text STOP at any time to cancel. Message and data rates may apply. View our Terms & Conditions and Privacy Policy.